Page6



(Now in April 2021 new LED headlights, scroll down for these.)

Fancy some LED lights

then try the following:-
Buy two 12v units from www.dun-bri.com
              2 off - 320.CRL80012v  LED light units               
2 off - CRL800/12v loading units       
or build your own loading units using 6x22ohm 10watt resistors, 3 in parallel each side. These are  needed to  simulate  21watt  lamps  to make the flasher unit  flash at the correct legal speed.
See website:-  www.dun-bri.com/showdetails.asp?id=355
-

Late 2014 - We  changed to LEDs, the front sidelights, front flashers, rear fog lights & reversing lights.


Some comparisons
New fog & reversing lights, we always chose to have them in pairs rather than GTM's one of each.
The Driving lights have proved easier to deal with than we thought, some of the heatsink fin needs to be removed to fit in the origional mount/adjustment unit.
We removed the old rusty adjuster bolts very carefully (these ABS mounts are like rocking horse s__t, impossible to find. We have found one very similar second hand for £15)

Simon found these LED driving lamps but they needed a little "adjusting" with a power file to be able to fit them in the mounts.

The driving/spot lamps are available in two styles, the ones on the left (in a white box) are not suitable as the heat sink is too large.
The number on the box in both cases is JG-1001.

The front lenses are different, on the left very little glass etching, on the right, circled, glass is etched.
Comparison of heatsink size, the one on the left will not fit in the standard mounting ring, the one on the right can be adjusted to fit using a power file.


  n

  One additional point here, we have removed the Dim Dip module (pink YWC 10050, it has seven pins) and used an old flasher unit to link pins 87 & 30 (we removed the flasher unit components). You could use a wire link with a 1/4" spade a terminal on each end. You can then remove the dim dip resistor from the right hand wheel arch. Ensure that you connect the earth wires together.

DimDip Relay
         
87 & 30  are the two which need linking, all others can be removed.
 
April 2021:- A  new aluminium mounting frame has been produced to use a new LED headlight unit, we have mounted these on the car & we will shortly be taking the car to our MOT centre to see  if it meets beam test.

Passed MOT July 2021
.

Hatch access for new headlight adjustment.


        
 


                                                                                                                                        New mounting ring 4 views




                                                 New mounting holes                                     New light unit in position


                                              Both sets of sidelights on                                            Dip beam pattern              

n
                                        Main beam pattern                                                                                   Bright enough?????

   
back to top of page


.